I know the ping response time from a specific ISP.Tcpdump is a quite heavy package, I think. Also in the mwan3 documentation it is only mentioned that the test is successful if the ping is successful. It is not clear to me how did you verify that exactly (tcpdump or something like that?). Inet6 fd22:bbe3:e6d8::1/60 scope global noprefixroute Inet6 fe80::e695:6eff:fe42:9733/64 scope link dadfailed tentativeĤ: teql0: mtu 1500 qdisc noop state DOWN group default qlen 100ĩ: wlan0: mtu 1500 qdisc noqueue state UP group default qlen 1000 ![]() Inet6 fe80::e695:6eff:fe42:9732/64 scope linkģ: eth1: mtu 1500 qdisc fq_codel state UP group default qlen 1000 Output of "ip a show" 1: lo: mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1 (see the expected outcome screenshot, they have 2 gateway with different metrics) The ping should be sent from my specified interface. But I am using 2 completely different interfaces and if I specify the interface to use, then the default gateway metric should not matter. This behavior is similar to IP aliasing on a single interface. If I use lower metric for eth0 gateway, then all pings are being sent from eth0 regardless of what interface I specify. Most probably because eth1 gateway has a lower metric. The expected outcome is also mentioned in the mwan3 documentation.īoth the ping commands are being sent from eth1 In the above commands, the ping should be sent via eth0 and eth1 respectively. Now, I am specifying the interface to use for ping using: ping -I eth0 8.8.8.8 Now, I connected the ISP cables to the respective pre-planned ports. The outputs of ip a show and ip route show are attached at the end of this post. I WILL USE THIS LOGICAL INTERFACE `LAN` IN /ETC/CONFIG/WIRELESS ISP-2 (172.30.138.151/24) (Planned about connecting it to WAN2-eth1) I used the following network config /etc/config/network config interface 'loopback' I recently got 2 connections from 2 different ISPs and thought to remove eth1 from the bridge and use it as a 2nd WAN port.īoth of my ISPs provided static IPs for router configuration. ![]() eth1 and wlan0 are bridged together ( br-lan). It has 3 interfaces: eth0 (single WAN port), eth1 (single LAN port), and wlan0 (WIFI).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |